![]() In Arduino.h I commented out the following lines: ![]() I commented these out, compiled, uploaded and can now connect and read data from the temp sensors using Pronterface. Unfortunately, this does not address the problem in this thread, but I managed to get my Melzi board talking again using Arduino 1.03, with these sanguino drivers HERE.Īdditionally, this would not compile (as mentioned above.) This was due to some duplicate declarations in the Arduino.h and pins_ardiono.h files in the above drivers. ![]() I have checked the nf and the section for the Atmega1284p is there but still not recognized? What would be wrong? Location? I can compile the sketch ok and get the binary size message, but when uploading to the board I get the following error:īinary sketch size: 46688 bytes (of a 129024 byte maximum)Īvrdude: AVR Part "atmega1284p" not found. Im new to the electronics side of the rep rap world, I am currently attempting to load Marlin firmware onto a Sanguino1.3a with Atmega1284P, I'm using Arduino 0023.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |